Fibre Glass Processors
Back to Engineering InsightsFGP Technical Bulletin
1 min read·Power PlantsCorrosion ResistanceMaterial Selection

From Steel to Composite: The Shift Toward FRP in Power Plants

Authored by FGP Technical Engineering Desk·ISO 9001:2008 Certified Facility · Rajkot, Gujarat

23+ years

60,000 sq ft plant

27+ products

ISO 9001:2008 certified

The Problem

Power generation infrastructure runs harsh: flue gas, moisture, and chemical scrubbing agents are exactly the conditions mild steel struggles with over a multi-decade plant lifetime. Painted or galvanized steel ducting and scrubber components need recoating or replacement on a cycle that FRP construction largely avoids.

The Shift

The shift isn't total — structural steel isn't going anywhere — but for the specific components that sit directly in a corrosive or high-moisture gas path (absorber and drying towers, scrubber ducting, cable trays in wet areas), composite construction removes an entire maintenance category: there's no rust to chase, no repainting schedule to plan around.

Why It Matters

It also changes the maintenance conversation from reactive to scheduled. A steel duct that's corroding from the inside gives limited warning before failure. FRP components degrade differently and more predictably, which matters more to a plant's maintenance planning than the material cost line item most comparisons stop at.

The Result

The practical result: newer emissions-control and gas-handling installations at power facilities increasingly spec composite construction for anything that sits in continuous contact with flue gas or scrubber liquor, and retrofit that decision into older plants component by component rather than all at once.

Engineering discipline

Engineering decisions we evaluate on every industrial build

No two chemical or structural specifications are identical, even at the same nominal capacity. Every FGP custom equipment project systematically resolves:

  • Capacity & working volume margins
  • Resin chemistry (Isophthalic vs Vinyl Ester vs Dual Laminate)
  • Laminate thickness & structural hoop stress calculation
  • Specific chemical concentration & operating temperature limits
  • Design standard compliance (BS 4994, ASTM D3299, ASTM D4097)
  • Nozzle orientation, manway positioning & installation constraints
  • Design life expectancy & preventive inspection protocol

Engineering consultation

Apply this engineering standard to your project

Share your project parameters with our Rajkot engineering desk — capacity, chemical exposure, operating temperature, and site layout — and we will calculate laminate specifications and provide a factory quotation.

Get in touch

Ready to engineer your composite equipment?
Consult directly with our plant engineers.

Over 23 years of proven composite engineering in Rajkot, Gujarat. We review CAD drawings, chemical media, and operating constraints.